PHOSPHORUS OXYBROMIDE, MOLTEN
| UN 编号 | UN2576 |
|---|---|
| 中文名称 | 三溴氧化磷,熔融的 |
| 英文名称 | PHOSPHORUS OXYBROMIDE, MOLTEN |
| 危险类别 | 第8类 |
| 包装类别 | II |
| 海洋污染物 | 原表未标注;须结合实际货物分类核对 |
| 有限数量 | 0 |
| 例外数量 | E0 |
| EmS 应急措施 | F-A, S-B |
无色液体,具有刺鼻气味,熔 点:56℃,与水剧烈反应,放 出白色烟雾状的有毒和腐蚀性 的溴化氢气体。与有机材料(如 木、棉花、稻草)剧烈反应会着 火。遇火时,放出剧毒腐蚀性 气体。遇潮时,对大多数金属 有强腐蚀性。蒸气和液体会灼 伤皮肤、眼睛和粘膜。以温度 高于其熔点的熔融状态运输。
Colourless liquid with a pungent odour. Melting point: 56 C. ° Reacts violently with water, evolving hydrogen bromide, a toxic and corrosive gas apparent as white fumes. Reacts violently with organic materials (such as wood, cotton, straw), causing fire. When involved in a fire, evolves highly toxic and corrosive gases. In the presence of moisture, highly corrosive to most metals. Vapours and liquid cause burns to skin, eyes and mucous membranes. Shipped molten above its melting point.
出处:IMDG Code 42-24 第 691 页
本条目在一览表中未列明包装导则。
一览表未列明本条目的 IBC 导则,请核对其他适用条款。
核对英文原文页面与脚注 ↗ · 官方 PDF 260–267
本可移动罐柜导则适用于第 1 类和第 3 至 9 类液体和固体物质,须满足第 4.2.1 节的一般规 定和第 6.7.2 节的要求。带 FRP 外壳的可移动罐柜导则适用于第 1、3、5.1、6.1、6.2、8 和 9 类或小类物质。此外,第 6.10 章的规定适用于带 FRP 外壳的可移动罐柜。
| 可移动罐柜导则 | 最低试验压力(bar) | 最小罐壳厚度(单位:mm–标准钢)(见第6.7.2.4条) | 安全减压规定 a(见第6.7.2.8条) | 底部开口规定 b(见第6.7.2.6条) |
|---|---|---|---|---|
| T7 | 4 | 见 6.7.2.4.2 | 正常 | 见 6.7.2.6.3 |
a 当标明“正常”时,除第 6.7.2.8.3 条外,第 6.7.2.8 条的所有规定均适用。 b 当此栏标明“不允许”时,当运输的物质为液体时,不允许底部开口(见第 6.7.2.6.1 条)。 当运输的物质在正常运输条件下遇到的所有温度下均为固体时,允许符合第 6.7.2.6.2 条规定 的底部开口。
来源 PDF 页码:371, 372 · 42-24
T1-T22 本可移动罐柜导则适用于第1类和第3至9类液体和固体物质,须满足第4.2.1节的一般规定和第6.7.2节的要求。带 FRP 外壳的可移动罐柜导则适用于第 1、3、5.1、6.1、6.2、8 和 9 类或小类物质。此外,第 6.10 章的规定适用于带 FRP 外壳的可移动罐柜。 最小罐壳厚度底部开口最低试验 (单位: mm-标准安全减压规定a 规定b 可移动罐柜导则压力钢) (见第6.7.2.8 (见第6.7.2.6 (bar) (见第6.7.2.4 条) 条) 条) 4 见6.7.2.4.2 正常见6.7.2.6.3
S T1 – T22 These portable tank instructions apply to liquid and solid substances of class 1 and classes 3 to 9. The general provisions of section 4.2.1 and the requirements of section 6.7.2 shall be met. The instructions for portable tanks with FRP shells apply to substances of classes or divisions 1, 3, 5.1, 6.1, 6.2, 8 and 9. Additionally, the provisions of chapter 6.10 apply to the portable tanks with FRP shells. Minimum shell thickness Pressure relief Bottom opening (in mm – reference provisionsa provisionsb instruction pressure (bar) steel) (see 6.7.2.8) (see 6.7.2.6) (see 6.7.2.4) 4 See 6.7.2.4.2 Normal See 6.7.2.6.3
对于在熔点以上运输的固体和高温液体,最大充灌度(单位为%)须按照第4.2.1.9.5条确定。
The maximum degree of filling (in%) for solids transported above their melting points and for elevated temperature liquids shall be determined in accordance with 4.2.1.9.5.
核对英文原文页面与脚注 ↗ · 官方 PDF 268–268
运输该物质时须配备自给式呼吸器,除非船上未配备《安全公约》第 II- 2/19(II-2/54)条所要求的的自给式呼吸器。
Self-contained breathing apparatus shall be provided when this substance is transported, unless no self-contained breathing apparatus, as required by SOLAS regulation II-2/19 (II-2/54), is on board.
条目 1 的包件标签与标记预览。请结合实际货物分类及特殊规定核对。
8本条目在 IMDG Code 42-24 一览表中未列明特殊规定。
| 积载与操作 | 积载类C SW2(Category C SW2) |
|---|---|
| 隔离 | SGG1 SG36 SG49 |
核对英文原文页面与脚注 ↗ · 官方 PDF 493–493
与SGG18 - 碱类“隔离”。
Stow “separated from” SGG18 – alkalis.
出口危险货物包装使用鉴定结果单(危包证)的办理逻辑,以及它和船级社证、钢瓶证、SOC 罐证分别在什么场景下用、向谁申请。
按IMDG42-24逐项核对DG申请表,区分规则必需内容和承运人补充字段,处理无包装组、条件性副危险和LQ等情况。
打开 UN2576 的交互查询,核对类别、包装与隔离要求。DG 表生成暂未开放使用。
打开规则查询 →