IMDGSEEK · 危险品海运查询 打开交互工作台 →

UN3482 碱金属分散体,易燃的或碱土金属分散体,易燃

ALKALI METAL DISPERSION, FLAMMABLE or ALKALINE EARTH METAL DISPERSION, FLAMMABLE

IMDG Code 42-24 第4.3类 包装类别 I 更新 2026-09-08

基本信息

UN 编号UN3482
中文名称碱金属分散体,易燃的或碱土金属分散体,易燃
英文名称ALKALI METAL DISPERSION, FLAMMABLE or ALKALINE EARTH METAL DISPERSION, FLAMMABLE
危险类别第4.3类(副危险 3)
包装类别I
海洋污染物
有限数量0
例外数量E0
EmS 应急措施F-G,S-N(F-G, S-N)

物质性质与外观

悬浮在易燃液体中的细碎碱金 属或碱土金属。与水分、水或 酸剧烈反应,放出氢气,反应 热可引燃氢气。

Finely divided alkali or alkaline earth metal suspended in a flammable liquid. Reacts violently with moisture, water or acids, evolving hydrogen, which may be ignited by the heat of the reaction.

出处:IMDG Code 42-24 第 757 页

包装要求

本条目适用的包装导则: P402 ;有限数量 0,例外数量 E0。

P402

P402 只要符合第4.1.1和4.1.3节的一般规定,允许使用下列包装: (1) 只要符合第 4.1.3.6 条一般规定的压力容器。压力容器须由钢制成,并在不低于 0.6MPa(6bar,表压)的压力下进行初次检验,并在以后每 10 年进行定期检验。运输过程中,液面须处于表压不低于20KPa(0.2bar)的惰性气体层下。 (2) 组合容器: 外容器: 桶(1A1、1A2、1B1、1B2、1N1、1N2、1H1、1H2、1D、1G); 箱(4A、4B、4N、4C1、4C2、4D、4F、4G、4H1、4H2); 罐(3A1、3A2、3B1、3B2、3H1、3H2)。 最大净质量如下的内容器: 玻璃 10 kg 金属或塑料 15 kg 每个内容器须装有螺纹封盖。 每个内容器须用惰性衬垫和吸收材料包裹,其数量足以吸收全部内装物。 每个外容器的最大净质量不超过125 kg。 (3) 钢桶(1A1),最大容积为250 L。 (4) 由钢桶或铝桶(6HA1 或 6HB1)中的塑料内容器组成的复合容器,最大容积为 250L。 特殊包装规定: PP31 对于UN 1389、1391、1392、1420、1421、1422、3148、3184(包装类II)、3185 (包装类 II)、3187(包装类 II)、3188(包装类 II)、3398(包装类 I)、3399(包装类I)和3482,包装须密封。

P402 The following packagings are authorized, provided that the general provisions of 4.1.1 and 4.1.3 are met: (1) Pressure receptacles, provided that the general provisions of 4.1.3.6 are met. They shall be made of steel and subjected to an initial test and periodic tests every 10 years at a pressure of not less than 0.6 MPa (6 bar, gauge pressure). During carriage, the liquid shall be under a layer of inert gas with a gauge pressure of not less than kPa (0.2 bar). (2) Combination packagings Outer packagings: Drums (1A1, 1A2, 1B1, 1B2, 1N1, 1N2, 1H1, 1H2, 1D, 1G); Boxes (4A, 4B, 4N, 4C1, 4C2, 4D, 4F, 4G, 4H1, 4H2); Jerricans (3A1, 3A2, 3B1, 3B2, 3H1, 3H2). Inner packagings with a maximum net mass as follows: Glass 10 kg Metal or plastics 15 kg Each inner packaging shall be fitted with threaded closures. Each inner packaging shall be surrounded by inert cushioning and absorbent material in a quantity sufficient to absorb the entire contents. The maximum net mass per outer packaging shall not exceed 125 kg. (3) Steel drums (1A1) with a maximum capacity of 250 L. (4) Composite packagings consisting of plastics receptacle in a steel or aluminium drum (6HA1 or 6HB1) with a maximum capacity of 250 L. Special packing provision: PP31 For UN Nos. 1389, 1391, 1392, 1420, 1421, 1422, 3148, 3184 (PG II), 3185 (PG II), 3187 (PG II), 3188 (PG II), 3398 (PG I), 3399 (PG I) and 3482, packagings shall be hermetically sealed.

出处:IMDG Code 42-24 第 205 页(4.1.4.1)

包装特殊规定

PP31

对于 UN 1131、1553、1693、1694、1699、1701、2478、2604、2785、3148、 3183、3184、3185、3186、3187、3188、3398(包装类 II 和 III)、3399(包装类 II 和III)、3413和3414,包装须气密封口。

For UN Nos. 1131, 1553, 1693, 1694, 1699, 1701, 2478, 2604, 2785, 3148, 3183, 3184, 3185, 3186, 3187, 3188, 3398 (PG II and III), 3399 (PG II and III), 3413 and 3414, packagings shall be hermetically sealed.

中型散装容器(IBC)要求

本条目无中型散装容器(IBC)运输要求。

罐柜运输要求

T13

T1-T22 本可移动罐柜导则适用于第1类和第3至9类液体和固体物质,须满足第4.2.1节的一般规定和第6.7.2节的要求。带 FRP 外壳的可移动罐柜导则适用于第 1、3、5.1、6.1、6.2、8 和 9 类或小类物质。此外,第 6.10 章的规定适用于带 FRP 外壳的可移动罐柜。 最小罐壳厚度底部开口最低试验 (单位: mm-标准安全减压规定a 规定b 可移动罐柜导则压力钢) (见第6.7.2.8 (见第6.7.2.6 (bar) (见第6.7.2.4 条) 条) 条) 6 6mm 正常不允许

S T1 – T22 These portable tank instructions apply to liquid and solid substances of class 1 and classes 3 to 9. The general provisions of section 4.2.1 and the requirements of section 6.7.2 shall be met. The instructions for portable tanks with FRP shells apply to substances of classes or divisions 1, 3, 5.1, 6.1, 6.2, 8 and 9. Additionally, the provisions of chapter 6.10 apply to the portable tanks with FRP shells. Minimum shell thickness Pressure relief Bottom opening (in mm – reference provisionsa provisionsb instruction pressure (bar) steel) (see 6.7.2.8) (see 6.7.2.6) (see 6.7.2.4) 6 6 mm Normal Not allowed

罐柜特殊规定

TP2

不得超过第4.2.1.9.3条中规定的充灌度。

The degree of filling prescribed in 4.2.1.9.3 shall not be exceeded.

TP7

须使用氮气或其他方式将蒸气空间中的空气排除。

Air shall be eliminated from the vapour space by nitrogen or other means.

TP42

可移动罐柜不可用于运输铯或铷分散体。

Portable tanks are not authorized for the transport of caesium or rubidium dispersions.

运输标签与标记

本货物包件应张贴以下标签与标记:

遇水放出易燃气体 4.3 4.3
遇水放出易燃气体 4.3
易燃液体 3 3
易燃液体 3

特殊规定(Special Provisions)

本条目适用特殊规定: 182183

SP 182

碱金属族包括:锂、钠、钾、铷和铯。

The group of alkali metals includes lithium, sodium, potassium, rubidium and caesium.

出处:IMDG Code 42-24 第 767 页

SP 183

碱土金属族包括:镁、钙、锶和钡。

The group of alkaline earth metals includes magnesium, calcium, strontium and barium.

出处:IMDG Code 42-24 第 767 页

积载与隔离

积载与操作积载类D H1(Category D H1)
隔离SG26 SG35

隔离代码(7.2.8)

SG26

补充:当在集装箱船上舱面积载时,须在横向与第 2.1 类和第 3 类保持最小两个箱位,当在滚装船上积载时,须在横向与第 2.1 类和第 3 类保持最小6米。

In addition: from goods of classes 2.1 and 3 when stowed on deck of a containership a minimum distance of two container spaces athwartship shall be maintained, when stowed on ro-ro ships a distance of 6 m athwartship shall be maintained.

SG35

与SGG1 - 酸类“隔离”。

Stow “separated from” SGG1 – acids.

同类其他 UN 号

延伸阅读

你正在查询 UN3482 · 碱金属分散体,易燃的或碱土金属分散体,易燃

要出这票货?直接生成 DG 申报资料

按 UN3482 自动带出类别、包装组、隔离要求与危包证清单,省掉翻书对表的时间。

生成 DG 申报资料 →
规则更新了?留个邮箱,43-26 上线时通知你