UN2870 氢硼化铝

液体。在空气中能自燃。与水 或蒸气反应，产生热或氢气， 可与空气形成爆炸性混合物。

Liquid. Ignites spontaneously in air. Reacts with water or steam to produce heat or hydrogen, which may form explosive mixtures with air.

出处：IMDG Code 42-24 第 708 页

P400

P400 只要符合第4.1.1和4.1.3节的一般规定，允许使用下列包装： （1） 符合第 4.1.3.6条的一般规定的压力容器。压力容器须由钢制成，并须在不低于 1MPa （10bar, 表压）的压力下进行初次试验，并在以后每隔10年进行定期检验。在运输过程中，液面须处于表压不低于20Kpa（0.2bar）的惰性气体层下。 （2） 箱 （4A、4B、4N、4C1、4C2、4D、4F 或 4G）、桶（1A1、1A2、1B1、1B2、 1N1、1N2、1D或1G）或罐 （3A1、3A2、3B1或3B2）内装有密封的金属罐，每个金属罐的容量不超过 1L，内容器为玻璃或金属，并配有密封垫。内容器须有螺纹封盖或用任何能够防止运输过程中撞击或振动导致封盖脱落或松动的物理固定装置。内容器的所有侧面均须垫以干燥、吸水、不易燃材料，其数量足以吸收全部内装物。内容器的最大充灌度不得超过其容量的90%。外包装的最大净重为125 kg。 （3） 钢桶、铝桶或其他金属桶（1A1、1A2、1B1、1B2、1N1 或 1N2）、罐（3A1、3A2、 3B1或 3B2）或箱（4A、4B或 4N），每个最大净重为 150kg，每个金属内罐密封，容量不超过 4L，封盖配有垫圈。内容器须有螺纹封盖或用任何能够防止运输过程中因撞击或振动而脱落或松动的物理固定装置。内容器的所有侧面均须垫以干燥、吸水、不易燃材料，衬垫量须足以吸收全部内装物。除垫衬材料外，每层内容器还须有分隔板隔开。内容器的最大充灌度不得超过其容量的90%。 特殊包装规定： PP86 对于UN 3392和3394，须使用氮气或其他方法消除蒸气空间中的空气。

P400 The following packagings are authorized, provided that the general provisions of 4.1.1 and 4.1.3 are met: (1) Pressure receptacles, provided that the general provisions of 4.1.3.6 are met. They shall be made of steel and shall be subjected to an initial test and periodic tests every 10 years at a pressure of not less than 1 MPa (10 bar, gauge pressure). During carriage, the liquid shall be under a layer of inert gas with a gauge pressure of not less than kPa (0.2 bar). (2) Boxes (4A, 4B, 4N, 4C1, 4C2, 4D, 4F or 4G), drums (1A1, 1A2, 1B1, 1B2, 1N1, 1N2, 1D or 1G) or jerricans (3A1, 3A2, 3B1 or 3B2) enclosing hermetically sealed metal cans with inner packagings of glass or metal, with a capacity of not more than 1 L each, having closures with gaskets. Inner packagings shall have threaded closures or closures physically held in place by any means capable of preventing back-off or loosening of the closure by impact or vibration during transport. Inner packagings shall be cushioned on all sides with dry, absorbent, non-combustible material in a quantity sufficient to absorb the entire contents. Inner packagings shall not be filled to more than 90% of their capacity. Outer packagings shall have a maximum net mass of 125 kg. (3) Steel, aluminium or metal drums (1A1, 1A2, 1B1, 1B2, 1N1 or 1N2), jerricans (3A1, 3A2, 3B1 or 3B2) or boxes (4A, 4B or 4N) with a maximum net mass of 150 kg each with hermetically sealed inner metal cans of not more than L capacity each, with closures fitted with gaskets. Inner packagings shall have threaded closures or closures physically held in place by any means capable of preventing back-off or loosening of the closure by impact or vibration during transport. Inner packagings shall be cushioned on all sides with dry, absorbent, non-combustible material in a quantity sufficient to absorb the entire contents. Each layer of inner packagings shall be separated by a dividing partition in addition to cushioning material. Inner packagings shall not be filled to more than 90% of their capacity. Special packing provision: PP86 For UN Nos. 3392 and 3394, air shall be eliminated from the vapour space by nitrogen or other means.

T21

须使用氮气或其他方式将蒸气空间中的空气排除。

Air shall be eliminated from the vapour space by nitrogen or other means.

为该物质指定的可移动罐柜导则适用于粒状和粉末状固体以及在高于其熔点的温度下装填和排放并作为固体块冷却和运输的固体。对于在高于其熔点的温度下运输的固体，见第4.2.1.19条。

The portable tank instruction assigned for this substance applies for granular and powdered solids and for solids which are filled and discharged at temperatures above their melting point and which are cooled and transported as a solid mass. For solids which are transported above their melting point, see 4.2.1.19.

在合理可行的条件下尽量保持干燥。

Keep as dry as reasonably practicable.

补充：当在集装箱船上舱面积载时，须在横向与第 2.1 类和第 3 类保持最小两个箱位，当在滚装船上积载时，须在横向与第 2.1 类和第 3 类保持最小6米。

In addition: from goods of classes 2.1 and 3 when stowed on deck of a containership a minimum distance of two container spaces athwartship shall be maintained, when stowed on ro-ro ships a distance of 6 m athwartship shall be maintained.